Tyco iSTAR Ultra Installation And Configuration Manual page 34

Installation
Ground Stud
(6-32)
For Shield Wire,
1 By Each Knockout
2–6 iSTAR Ultra Installation and Configuration Guide
2. Open the enclosure door and disconnect the grounding wire on the door.
3. Carefully lift the door off the hinges, and place it on a padded surface.
4. Verify that the upper mounting screws (or equivalent) are in place on the mounting site
for the keyhole locations.
See Figure 2-1 on
NOTE
knockouts.
Figure 2-1: iSTAR Ultra Controller with Door Removed (Two ACMs Mounted)
LCD
Keyhole
Mounting
Slot (2)
E-Net
USB Cables
Assorted
Knockouts
5. Align the mounting keyhole slots at the upper back of the enclosure with the two upper
mounting screws, and lower the enclosure into position.
6. Install the three lower mounting screws and the remaining top mounting screw in
between the two keyhole mounts.
7. Attach the conduit couplings to the knockout openings as needed to comply with local
code requirements.
8. Reattach the grounding wire between the door and the enclosure.
page 2-6 for the location of the keyhole slots, screws, and
General Controller
Module (GCM)
Cabinet/Enclosure
GCM
Reader & Logic Power
ACM 1
Reader & Logic Power
ACM 2
Access
Lower Mounting
Control
Hole (3)
Module
(ACM)
Assorted Knockouts
LCD
LCD
Tamper Switch
Tamper
Note: ACM Lock
Power IN supplies
the WET relay outputs.
Assorted
Knockouts