Switches And Jumpers; Sw10 - Acm Mcu Reset; J1 Usb Type B 2.0 Port; Sw32 Acm Address Switch - Tyco iSTAR Ultra Installation And Configuration Manual

Switches and Jumpers

SW10 - ACM MCU Reset

SW10 reboots both MCUs. It should only be used when it seems the ACM is not responding.

J1 USB Type B 2.0 Port

Communication link to the GCM.

SW32 ACM Address Switch

The address switch is used to identify the ACM boards connected to the GCM. Each ACM
address switch must be set differently before you configure the board.
SW32-1 = OFF ACM is unit 0 (zero)

SW32-1 = ON ACM is unit 1

Figure 6-3: ACM - Left Side
iSTAR Ultra Installation and Configuration Guide
Access Control Module
6–5