Wet Wiring For A Magnetic Lock - Tyco iSTAR Ultra Installation And Configuration Manual

Access Control Module
6–14 iSTAR Ultra Installation and Configuration Guide

Wet Wiring for a Magnetic Lock

Magnetic Locks are normally energized so the GND and NC pins are used in this case. Notice
that jumper is in the Wet position, as shown in
Table 6-4 on page 6-14 summarizes the function and designation of the ACM LEDs.
LED
DS21
DS52
DS54
Figure 6-12: Wet NO Latch
Figure 6-13
Figure 6-13: WET Magnetic Lock
Table 6-4: ACM LED Functions
Function
Main Power - Reader Power - J4
Main Power - LOCK 1 - J2
Main Power - LOCK 2 - J3
on page 6-14.
Comment
12 Vdc
12 or 24 Vdc
12 or 24 Vdc