Setting The Lcd Message Display - Tyco iSTAR Ultra Installation And Configuration Manual

Setting the LCD Message Display

Setting the LCD Message Display

10–2 iSTAR Ultra Installation and Configuration Guide
The iSTAR Ultra includes an LCD display for status and diagnostic messages. SW3 is an
onboard 16-position rotary switch. Most of the positions are used to control LCD diagnostics.
Figure 10-1 shows the location of the rotary switch SW3. See
summary of SW3 settings.
Position Description
0 ICU Block Off (Read/Write/Update) Display General Messages.
1 Display card data from last card read, 7 second LCD display (slow mode).
2 Display card data from last card read, 2 second LCD display (fast mode).
3 Display supervised input changes, 2 second LCD display (slow mode).
4 Display supervised input changes, 1 second LCD display (fast mode).
5 Display manual output changes (include readers and R/8 boards), 2 second LCD display
(slow mode).
6 Display manual output changes (include readers and R/8 boards), 1 second LCD display (fast
mode).
7 Not used.
Figure 10-1: SW1 Location
Table 10-1: iSTAR Ultra Rotary Switch Functions
Table 10-1 on page 10-2 for a