DX100
6
Data Protection
6.2
Operation When VERIFY ERROR Occurs
3. Move the cursor to "Safety Unit FLASH Reset" and press [ENTER].
4. The dialog box "Reset?" is displayed. Select [YES].
– The data of the safety unit is re-set. A few seconds later, the buzzer
sounds and the data setting is completed.
5. When the data reset is completed, turn the control power OFF and
then turn the power ON again.
To set the safety unit data, the security mode must be MAN-
NOTE
AGEMENT MODE or higher. Thus, the administrator or a
user with higher privilege must perform these settings.
6-3
HW0486052
HW0486052
47/56