Setting The Printer; Shutting Down - Dräger Babylog 8000 plus Instructions For Use Manual

Operation

Shutting down

Select the desired parity with the keys »
and » «:
NONE
or
EVEN
or
ODD
When using a printer, select »NONE«.
The default factory settings are:
Baudrate 9600
Parity NONE
Stop bits 1 (fixed)
Data bits 8 (fixed)
Exit from the menu:
Press the key »
The settings remain stored even if the ventilator is switched off.

Setting the printer

The printer must be configured as follows:
Baudrate same as Babylog 8000 plus
Parity none
Data bits 8
Handshake mode XON/XOFF
Alternate control sequence mode
Shutting down
After disconnecting the patient.
On the rear of the ventilator:
1 Swing the protective cover over the main switch to one side
and
2 press the button fully inwards and release it to switch the
ventilator off.
Set the main switch of the humidifier to »0«.
Disconnect the plugs of all electrical and gas supplies from
their sockets.
76
«
«.
1
2