HEIDENHAIN TNC 620 User Manual page 290

13
Using Touch Probe Cycles
13.1 General information about touch probe cycles
Defining the touch probe cycle in the Programming and Editing
mode of operation
The soft-key row shows all available touch probe
functions divided into groups.
Select the desired probe cycle group, for
example datum setting. Cycles for automatic tool
measurement are available only if your machine has
been prepared for them.
Select a cycle, e.g. datum setting at pocket center.
The TNC initiates the programming dialog and asks
for all required input values. At the same time a
graphic of the input parameters is displayed in the
right screen window. The parameter that is asked
for in the dialog prompt is highlighted.
Enter all parameters requested by the TNC and
conclude each entry with the ENT key.
The TNC ends the dialog when all required data has
been entered
Group of measuring cycles
Cycles for automatic measurement
and compensation of workpiece
misalignment
Cycles for automatic workpiece
presetting
Cycles for automatic workpiece
inspection
Special cycles
Cycles for automatic tool
measurement (enabled by the
machine tool builder)
290
Soft key Page
298
320
374
418
466
TNC 620 | User's Manual Cycle Programming | 3/2014
NC blocks
5 TCH PROBE 410 DATUM INSIDE
RECTAN.
Q321=+50 ;CENTER IN 1ST AXIS
Q322=+50 ;CENTER IN 2ND AXIS
Q323=60 ;FIRST SIDE LENGTH
Q324=20 ;2ND SIDE LENGTH
Q261=-5 ;MEASURING HEIGHT
Q320=0 ;SET-UP CLEARANCE
Q260=+20 ;CLEARANCE HEIGHT
Q301=0 ;MOVE TO CLEARANCE
Q305=10 ;NO. IN TABLE
Q331=+0 ;DATUM
Q332=+0 ;DATUM
Q303=+1 ;MEAS. VALUE
TRANSFER
Q381=1 ;PROBE IN TS AXIS
Q382=+85 ;1ST CO. FOR TS AXIS
Q383=+50 ;2ND CO. FOR TS AXIS
Q384=+0 ;3RD CO. FOR TS AXIS
Q333=+0 ;DATUM