Characteristics Common To All Touch Probe Cycles For Measuring Workpiece Misalignment - HEIDENHAIN TNC 620 User Manual

Hide thumbs Also See for TNC 620:

Table of Contents

Fundamentals 14.1

Characteristics common to all touch probe cycles for

measuring workpiece misalignment

For Cycles 400, 401 and 402 you can define through parameter

Q307 Default setting for basic rotation whether the

measurement result is to be corrected by a known angle # (see

figure at right). This enables you to measure the basic rotation

against any straight line

of the workpiece and to establish the

reference to the actual 0° direction 2.

TNC 620 | User's Manual Cycle Programming | 3/2014