HEIDENHAIN TNC 620 User Manual page 33

15 Touch Probe Cycles: Automatic Datum Setting........................................................................ 319
15.1 Fundamentals...................................................................................................................................... 320
Overview............................................................................................................................................... 320
Characteristics common to all touch probe cycles for datum setting...................................................322
15.2 DATUM SLOT CENTER (Cycle 408, DIN/ISO: G408, software option 17)....................................... 324
Cycle run............................................................................................................................................... 324
Please note while programming:.......................................................................................................... 325
Cycle parameters.................................................................................................................................. 326
15.3 DATUM RIDGE CENTER (Cycle 409, DIN/ISO: G409, software option 17)..................................... 328
Cycle run............................................................................................................................................... 328
Please note while programming:.......................................................................................................... 328
Cycle parameters.................................................................................................................................. 329
15.4 DATUM FROM INSIDE OF RECTANGLE (Cycle 410, DIN/ISO: G410, software option 17).............331
Cycle run............................................................................................................................................... 331
Please note while programming:.......................................................................................................... 332
Cycle parameters.................................................................................................................................. 333
15.5 DATUM FROM OUTSIDE OF RECTANGLE (Cycle 411, DIN/ISO: G411, software option 17)......... 335
Cycle run............................................................................................................................................... 335
Please note while programming:.......................................................................................................... 335
Cycle parameters.................................................................................................................................. 336
15.6 DATUM FROM INSIDE OF CIRCLE (Cycle 412, DIN/ISO: G412, software option 17).....................338
Cycle run............................................................................................................................................... 338
Please note while programming:.......................................................................................................... 339
Cycle parameters.................................................................................................................................. 340
15.7 DATUM FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413, software option 17)................. 343
Cycle run............................................................................................................................................... 343
Please note while programming:.......................................................................................................... 343
Cycle parameters.................................................................................................................................. 344
15.8 DATUM FROM OUTSIDE OF CORNER (Cycle 414, DIN/ISO: G414, software option 17).............. 347
Cycle run............................................................................................................................................... 347
Please note while programming:.......................................................................................................... 348
Cycle parameters.................................................................................................................................. 349
TNC 620 | User's Manual Cycle Programming | 3/2014
33