Touch Probe Cycles: Automatic Measurement Of Workpiece Misalignment; 14.1 Fundamentals; Overview - HEIDENHAIN TNC 620 User Manual

14
Touch Probe Cycles: Automatic Measurement of Workpiece
Misalignment

14.1 Fundamentals

14.1 Fundamentals

Overview

When running touch probe cycles, Cycle 8 MIRROR
IMAGE, Cycle 11 SCALING and Cycle 26 AXIS-
SPECIFIC SCALING must not be active.
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe.
Refer to your machine manual.
The TNC provides five cycles that enable you to measure and
compensate workpiece misalignment. In addition, you can reset a
basic rotation with Cycle 404:
Cycle
400 BASIC ROTATION
Automatic measurement using two
points. Compensation via basic
rotation.
401 ROT OF 2 HOLES
Automatic measurement using
two holes. Compensation via basic
rotation.
402 ROT OF 2 STUDS
Automatic measurement using
two studs. Compensation via basic
rotation.
403 ROT IN ROTARY AXIS
Automatic measurement using two
points. Compensation by turning the
table.
405 ROT IN C AXIS
Automatic alignment of an angular
offset between a hole center and the
positive Y axis. Compensation via
table rotation.
404 SET BASIC ROTATION
Setting any basic rotation.
298
Soft key Page
300
303
306
309
313
312
TNC 620 | User's Manual Cycle Programming | 3/2014