Datum From Inside Of Rectangle (Cycle 410, Din/Iso: G410, Software Option 17); Cycle Run - HEIDENHAIN TNC 620 User Manual

DATUM FROM INSIDE OF RECTANGLE (Cycle 410, DIN/ISO: G410,
15.4 DATUM FROM INSIDE OF RECTANGLE
(Cycle 410, DIN/ISO: G410, software
option 17)

Cycle run

Touch Probe Cycle 410 finds the center of a rectangular pocket and
defines its center as datum. If desired, the TNC can also enter the
coordinates into a datum table or the preset table.
1 Following the positioning logic, the TNC positions the touch
probe at rapid traverse (value from FMAX column) (see
"Executing touch probe cycles", page 294) to touch point 1. The
TNC calculates the touch points from the data in the cycle and
the safety clearance from the SET_UP column of the touch
probe table.
2 Then the touch probe moves to the entered measuring height
and runs the first probing process at the probing feed rate
(column F).
3 Then the touch probe moves either paraxially at measuring
height or at clearance height to the next starting point
probes the second touch point.
4 The TNC positions the probe to starting point
4
starting point to probe the third and fourth touch points.
5 Finally the TNC returns the touch probe to the clearance height
and processes the determined datum depending on the cycle
parameters Q303 and Q305.
6 If desired, the TNC subsequently measures the datum in the
touch probe axis in a separate probing and saves the actual
values in the following Q parameters.
Parameter number
Q151
Q152
Q154
Q155
TNC 620 | User's Manual Cycle Programming | 3/2014
3
and then to
Meaning
Actual value of center in reference
axis
Actual value of center in minor axis
Actual value of length in the reference
axis
Actual value of length in the minor
axis
software option 17)
2
and
15
15.4
331