HEIDENHAIN TNC 620 User Manual page 394

16
Touch Probe Cycles: Automatic Workpiece Inspection
16.7 MEASURE RECTANGLE INSIDE (Cycle 423, DIN/ISO: G423, software
option 17)
Measuring log Q281: Define whether the TNC
should create a measuring log:
0: Do not create a measuring log
1: Create a measuring log: The TNC saves the
file TCHPR423.TXT
TNC:\.
2: Interrupt program run and output measuring log
to the TNC screen. Resume program run with NC
Start.
PGM stop if tolerance error Q309: Definition of
whether in the event of a violation of tolerance
limits the TNC is to interrupt program run and output
an error message:
0: Do not interrupt program run, do not output an
error message
1: Interrupt program run and output an error
message
Tool for monitoring Q330: Definition of whether
the TNC is to monitor the tool (see "Tool
monitoring", page 378). Input range 0 to 32767 .9,
alternatively tool name with maximum of 16
characters
0: Monitoring inactive
>
394
as standard in the directory
0: Tool number in the tool table TOOL.T
log
TNC 620 | User's Manual Cycle Programming | 3/2014