Differences Between Cycles 31 To 33 And Cycles 481 To 483 - HEIDENHAIN TNC 620 User Manual

You can program the cycles for tool measurement in the
Programming mode of operation using the TOUCH PROBE key. The
following cycles are available:
Cycle
Calibrating the TT, Cycles 30 and 480
Calibrating the wireless TT 449, Cycle 484
Measuring the tool length, Cycles 31 and 481
Measuring the tool radius, Cycles 32 and 482
Measuring the tool length and radius, Cycles 33 and 483
The measuring cycles can be used only when the
central tool file TOOL.T is active.
Before working with the measuring cycles, you must
first enter all the required data into the central tool
file and call the tool to be measured with TOOL
CALL.
Differences between Cycles 31 to 33 and Cycles 481 to
483
The features and the operating sequences are absolutely identical.
There are only two differences between Cycles 31 to 33 and Cycles
481 to 483:
Cycles 481 to 483 are also available in controls for ISO
programming under G481 to G483.
Instead of a selectable parameter for the status of the
measurement, the new cycles use the fixed parameter Q199.
TNC 620 | User's Manual Cycle Programming | 3/2014
Fundamentals 19.1
New Old
format format
19
Page
472
473
474
476
478
467