Overview - HEIDENHAIN TNC 620 User Manual

Characteristics of the fixed cycles
The TNC automatically positions the tool to the set-up clearance
before each cycle–position the tool to a safe position before the
cycle call.
Each level of infeed depth is milled without interruptions since the
cutter traverses around islands instead of over them.
The radius of "inside corners" can be programmed—the tool
keeps moving to prevent surface blemishes at inside corners (this
applies to the outermost pass in the Rough-out and Side Finishing
cycles).
The contour is approached in a tangential arc for side finishing.
For floor finishing, the tool again approaches the workpiece on a
tangential arc (for spindle axis Z, for example, the arc may be in
the Z/X plane).
The contour is machined throughout in either climb or up-cut
milling.
The machining data (such as milling depth, finishing allowance and
set-up clearance) are entered as CONTOUR DATA in Cycle 20.

Overview

Cycle
14 CONTOUR GEOMETRY (essential)
20 CONTOUR DATA (essential)
21 PILOT DRILLING (optional)
22 ROUGH-OUT (essential)
23 FLOOR FINISHING (optional)
24 SIDE FINISHING (optional)
Enhanced cycles:
Cycle
25 CONTOUR TRAIN
TNC 620 | User's Manual Cycle Programming | 3/2014
Soft key Page
174
179
181
183
186
187
Soft key Page
189
SL Cycles
...
99 END PGM SL2 MM
7
7.1
173