Table of Contents
Advertisement
Chapter 5: Important Setup Parameters
5.1. Important Setup Parameters
The AERO.10 includes some key parameters which are critical to get set correctly.
This chapter discusses some of them, but is not an exhaustive list of settings and
parameters.
These parameters may be configured either from the Front Panel control or via
NfRemote. For speed and ease of configuration, setting these parameters via
NfRemote will be explained in this chapter. The parameters being adjusted will be
found in consistent locations in the menu tree whether they are being accessed from
the Front Panel or via NfRemote (i.e. Clock Reference will be found in System >
I/O Setup > H/W I/O Setup in both the Front Panel menu and in NfRemote)
5.2. Unit Configuration Setup Parameters
5.2.1. Password
A password must ALWAYS be set in the AERO.10. The factory set password is 1234.
If you choose to change the password keep it in a safe place. If the password is lost
or removed the unit must be sent back to the factory to recover front panel and
remote control of the unit.
To change the password:
System > Network > Password
Make sure you save your new password somewhere safe!!
Note!
The factory set password is 1234. If you change the password,
keep it in a safe place. If the password is lost or removed, the unit
must be returned to the factory.
53
Advertisement
Table of Contents
