Table of Contents
Advertisement
Chapter 2: Getting Started
2.1. Start Here
We realize that you are eager to get your AERO.10 up and running as soon as
possible. Of course, we recommend that you take the time to read through this
manual and thoroughly familiarize yourself with the AERO.10 first. Though to be
completely honest, we sometimes have a hard time following our own advice when
we get a new piece of equipment (we are audio and technology nerds ourselves,
after all). So, as a reasonable compromise, we are including some simple setup
instructions in this chapter, which should help you quickly get started while you
read and understand this manual.
2.2. Quick Start
This quick start section is designed to walk you through the initial installation and
setup of your new AERO.10 DTV Audio Processor.
It is possible to configure the unit with the front panel controls and display, but
doing so by way of the remote client, NfRemote, is much easier and offers a number
of benefits.
2.2.1. Racking and Power
Use all four rack screws and allow 1RU of space above and below the unit whenever
possible. There is an air intake on the right side of the unit and an exhaust fan on the
left side that must not be blocked.
Dual, universal power supplies are provided along with two IEC power cables.
Ideally, each supply should be fed from a different circuit. In all cases both supplies
should be used.
There is no on/off switch, the AERO.10 will turn on when power is applied. The unit
may be shut down simply by removing power to it. No harm to the AERO.10 will
occur in doing so.
2.2.2. Installing NfRemote
20
Advertisement
Table of Contents
