Table of Contents
Advertisement
1.6. Installation and Mounting
1.6.1. Installation
Use all four rack screws and allow 1RU of space above and below the unit whenever
possible. There is an air intake on the right side of the unit and an exhaust fan on the
left side that must not be blocked.
1.6.2. Power
Dual, universal power supplies are provided along with two IEC power cables.
Redundant power supplies are included primarily to protect you from interruptions
on the power line. Ideally, each power supply should be fed from a different circuit,
and it is strongly recommended that an uninterruptable power supply (UPS) is used
on at least one of the power supplies. In all cases both supplies should be used.
There is no on/off switch, the AERO.10 will turn on when power is applied to either
power supply. The unit may be shut down simply by removing power to it. No
harm to the AERO.10 will occur in doing so.
1.7. Block diagram
1.7.1. Block diagram
The block diagram of the AERO.10 is shown below:
18
Advertisement
Table of Contents
