Cisco TelePresence SX20 Codec Reference Manual page 115

Cisco TelePresence SX20 Codec
Contents Introduction
Presentation commands
xCommand Presentation Start
Open a media stream from the selected presentation source.
PresentationSource: Select the video input source to be used for presentation.
SendingMode: Select whether the presentation is shown locally or locally and remotely.
Instance: Select which local presentation you wish to start.
Requires user role: USER
Parameters:
PresentationSource: <1..2>
SendingMode: <LocalRemote/LocalOnly>
Example:
xCommand Presentation Start PresentationSource:2
xCommand Presentation Stop
Stop the media stream from the presentation source.
Instance: Select which local presentation you wish to stop.
Requires user role: USER
Parameters:
Instance: <1 / 2 / 3 / 4 / 5 / 6>
Example:
xCommand Presentation Stop
SX20 Codec API Reference Guide TC7.3, OCTOBER 2015.
D14949.13
About the API xConfiguration
Preset commands
xCommand Preset Activate
xCommand Preset Clear
115
xCommand xCommand
Activate one of the stored local presets.
Note that information about all video input sources, and pan, tilt, zoom and focus values for all
cameras are included in the same preset. In contrast, the xCommand Camera Preset commands
applies to individual cameras only.
PresetId: The ID of the preset you want to activate.
Requires user role: USER
Parameters:
PresetId(r): <1..15>
Example:
xCommand Preset Activate PresetId:3
Delete a preset.
Note that information about all video input sources, and pan, tilt, zoom and focus values for all
cameras are included in the same preset. In contrast, the xCommand Camera Preset commands
applies to individual cameras only.
PresetId: The ID of the preset you want to delete.
Requires user role: USER
Parameters:
PresetId(r): <1..15>
Example:
xCommand Preset Clear PresetId:3
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.