Cisco TelePresence SX20 Codec Reference Manual page 55

Cisco TelePresence SX20 Codec
Contents Introduction
xConfiguration NetworkServices SSH AllowPublicKey
Secure Shell (SSH) public key authentication can be used to access the codec.
Requires user role: ADMIN
Value space: <Off/On>
Off: The SSH public key is not allowed.
On: The SSH public key is allowed.
Example: xConfiguration NetworkServices SSH AllowPublicKey: On
xConfiguration NetworkServices CTMS Mode
This setting determines whether or not to allow multiparty conferences controlled by a Cisco
TelePresence Multipoint Switch (CTMS).
Video systems are able to initiate or join non-encrypted multiparty conferences controlled by CTMS
version 1.8 or later. Encrypted conferences are supported as from software versions CTMS 1.9.1.
Encryption is addressed in the NetworkServices CTMS Encryption setting.
Requires user role: ADMIN
Value space: <Off/On>
Off: Multiparty conferencing via CTMS is prohibited.
On: Multiparty conferencing via CTMS is allowed.
Example: xConfiguration NetworkServices CTMS Mode: On
xConfiguration NetworkServices CTMS Encryption
This setting indicates whether or not the video system supports encryption when participating in a
multiparty meeting controlled by a Cisco TelePresence Multipoint Switch (CTMS).
CTMS allows three security settings for meetings: non-secure (not encrypted), best effort
(encrypted if all participants support encryption, otherwise not encrypted) and secure (always
encrypted).
Requires user role: ADMIN
Value space: <Off/BestEffort>
Off: The video system does not allow encryption and therefore cannot participate in a secure
CTMS meeting (encrypted). When participating in a best effort CTMS meeting, the meeting will be
downgraded to non-secure (not encrypted).
BestEffort: The video system can negotiate encryption parameters with CTMS and participate in a
secure CTMS meeting (encrypted). Do not use this value if the CTMS version is older than 1.9.1.
Example: xConfiguration NetworkServices CTMS Encryption: Off
SX20 Codec API Reference Guide TC7.3, OCTOBER 2015.
D14949.13
About the API xConfiguration xConfiguration
xConfiguration NetworkServices UPnP Mode
xConfiguration NetworkServices UPnP Timeout
55
xCommand
Fully disable UPnP (Universal Plug and Play), or enable UPnP for a short time period after the video
system has been switched on or restarted.
The default operation is that UPnP is enabled when you switch on or restart the video system. Then
UPnP is automatically disabled after the timeout period that is defined in the NetworkServices UPnP
Timeout setting.
When UPnP is enabled, the video system advertises its presence on the network. The
advertisement permits a Touch controller to discover video systems automatically, and you do not
need to manually enter the video system's IP address in order to pair the Touch controller.
Requires user role: ADMIN
Value space: <Off/On>
Off: UPnP is disabled. The video system does not advertise its presence, and you have to enter
the video system's IP address manually in order to pair a Touch controller to the video system.
On: UPnP is enabled. The video system advertises its presence until the timeout period expires.
Example: xConfiguration NetworkServices UPnP Mode: On
Define for how many seconds UPnP shall stay enabled after the video system is switched on or
restarted. The NetworkServices UPnP Mode setting must be On for this setting to take any effect.
Requires user role: ADMIN
Value space: <0..3600>
Range: Select a value between 0 and 3600 seconds.
Example: xConfiguration NetworkServices UPnP Timeout: 600
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.