Experimental Commands - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction
xCommand Video Selfview Set
Sets self-view on/off and specifies its size and position. If the parameter is not specified, current
value is used.
Mode: Selfview on/off
FullscreenMode: Self-view in fullscreen or pip.
PIPPosition: Predefined PIP positions.
FullscreenMode: Choose between displaying the self-view in full screen or not.
PIPPosition: Select the position for the self-view image.
CenterLeft: The self-view PiP appears on the left side of the screen, in center.
CenterRight: The self-view PiP appears on the right side of the screen, in center.
LowerLeft: The self-view PiP appears in the lower left corner of the screen.
LowerRight: The self-view PiP appears in the lower right corner of the screen.
UpperCenter: The self-view PiP appears on top of the screen, in center.
UpperLeft: The self-view PiP appears in the upper left corner of the screen.
UpperRight: The self-view PiP appears in the upper right corner of the screen.
OnMonitorRole: Displays self-view on monitors with this role.
Requires user role: ADMIN
Parameters:
Mode: <On/Off>
FullscreenMode: <On/Off>
PIPPosition: <CenterLeft/CenterRight/LowerLeft/LowerRight/UpperCenter/UpperLeft/
UpperRight>
OnMonitorRole: <First/Fourth/Second/Third>
Example:
Example 1
xCommand Video Selfview Set Mode: On FullscreenMode: Off PIPPosition:
CenterLeft OnMonitorRole: First
Example 2
xCommand Video Selfview Set FullscreenMode: On OnMonitorRole: Second
SX20 Codec API Reference Guide TC7.3, OCTOBER 2015.
D14949.13
About the API xConfiguration

Experimental commands

The Experimental commands are for testing only and should not be used unless agreed with Cisco.
These commands are not documented and WILL change in later releases.
127
xCommand xCommand xStatus
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
API Reference Guide
Appendices