Key Commands; Xcommand Key Click; Xcommand Key Press; Xcommand Key Release - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction

Key commands

xCommand Key Click

Emulates a remote control key press, followed by a key release.
Requires user role: ADMIN
Parameters:
Key(r): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/Layout/
Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/Square/SrcAux/SrcCamera/
SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/VolumeUp/ZoomIn/ZoomOut>
Example:
xCommand Key Click Key:Down

xCommand Key Press

Emulates a remote control key press without releasing it. The Key Press command must be followed
by a Key Release command to emulate releasing the key.
Requires user role: ADMIN
Parameters:
Key(r): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/Layout/
Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/Square/SrcAux/SrcCamera/
SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/VolumeUp/ZoomIn/ZoomOut>
Example:
xCommand Key Press Key:Home

xCommand Key Release

Emulates a remote control key release. The Key Release command is issued after a Key Press
command.
Requires user role: ADMIN
Parameters:
Key(r): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/Layout/
Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/Square/SrcAux/SrcCamera/
SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/VolumeUp/ZoomIn/ZoomOut>
Example:
xCommand Key Release Key:Home
SX20 Codec API Reference Guide TC7.3, OCTOBER 2015.
D14949.13
About the API xConfiguration

Logging commands

xCommand Logging ExtendedLogging Start

xCommand Logging ExtendedLogging Stop

105
xCommand xCommand
Turns on the extended logging, which stores more information than regular logging in the log files.
You can determine the duration in seconds. Note that extended logging uses more of your video
system's resources, and should only be used when troubleshooting an issue.
Requires user role: USER
Parameters:
Duration: <1..600>
Example:
xCommand Logging ExtendedLogging Start Duration: 20
Stops the logging started with xCommand SystemUnit Diagnostics ExtendedLogging Start.
Requires user role: USER
Example:
xCommand Logging ExtendedLogging Stop
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.