The Camctrlpip Commands; Xcommand Camctrlpip; The Camera Commands; Xcommand Camera Pantiltreset - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction

The CamCtrlPip commands

xCommand CamCtrlPip

Show or hide the camera selfview in a small window (picture in picture).
Requires user role: USER
Parameters:
Mode(r): <On/Off>
Example:
xCommand CamCtrlPip Mode: On
*r CamCtrlPipResult (status=OK):
** end
D14641.06 Codec C90 API Reference Guide TC5.0 November 2011.
© 2010-2011 Cisco Systems, Inc. All rights reserved.
About the API xConfiguration

The Camera commands

xCommand Camera PanTiltReset

xCommand Camera PositionReset

83
xCommand xCommand
The camera is reset to its default values for pan and tilt. If the camera is daisy chained, the CameraId
is given by its place in the chain.
Requires user role: USER
Parameters:
CameraId(r): <1..7>
Example:
xCommand Camera PanTiltReset CameraId:1
OK
*r PanTiltResetResult (status=OK):
** end
Reset the camera position the the deafult position.
Requires user role: USER
Parameters:
CameraId(r): <1..7>
Example:
xCommand Camera PositionReset CameraId:1
OK
*r CameraPositionResetResult (status=OK):
** end
API Reference Guide
xStatus Appendices
www.cisco.com