Conference Configuration - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction
xConfiguration Cameras Camera [1..1] Whitebalance Level
Set the whitebalance level. NOTE: Requires the Camera Whitebalance Mode to be set to manual.
Requires user role: ADMIN
Value space: <1..16>
Range: Select a value from 1 to 16.
Example: xConfiguration Cameras Camera 1 Whitebalance Level: 1
xConfiguration Cameras Camera [1..1] DHCP
Applies to cameras which support DHCP (for example the Cisco TelePresence PrecisionHD 1080p
12X camera). The camera must be connected to a LAN. When set, the command enables support
for SW upgrade of daisy chained cameras. It will enable the camera's DHCP function and force
start of MAC and IP address retrieval. Remember to reset the DHCP when the camera is no longer
connected to a LAN.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable DHCP in the camera. NOTE: This setting should be applied when the camera is not
connected to a LAN.
On: Enable DHCP in the camera. The camera is automatically re-booted. After re-boot the DHCP
is started and the IP address will be retrieved. Run the commnand "xStatus Camera" for result.
Example: xConfiguration Cameras Camera 1 DHCP: Off
SX20 Codec API Reference Guide TC6.2, JULY 2013.
D14949.04
About the API xConfiguration xConfiguration

Conference configuration

xConfiguration Conference [1..1] CallProtocolIPStack
xConfiguration Conference [1..1] LyncCompatibility
xConfiguration Conference [1..1] AutoAnswer Mode
32
xCommand
Select if the call protocol (SIP, H323) should use the IPv4 or IPv6 address when the system has IP
connectivity on both protocol versions at the same time, e.g. when the network interface (Network
IPStack) is set to Dual.
Requires user role: ADMIN
Value space: <IPv4/IPv6>
IPv4: When set to IPv4, the call protocol (SIP, H323) will use IPv4.
IPv6: When set to IPv6, the call protocol (SIP, H323) will use IPv6.
Example: xConfiguration Conference 1 CallProtocolIPStack: IPv4
The TelePresence endpoints, running TC6.2 software, or later are Lync 2013 ready.
NOTE: Requires version X8 of the VCS (Video Communication Server). You can make calls to Lync
2013 from your TelePresence endpoint and vice versa and the call will have support for audio and
video.
NOTE: To make Lync 2013 contacts available in the phonebook on the endpoint the TMS
(TelePresence Management System) version 13.x, or later, must be configured.
Requires user role: ADMIN
Value space: <Off/On>
Off: When set to Off, Lync 2013 compatibility on the endpoint is disabled. This is the default value.
On: When set to Off, Lync 2013 compatibility on the endpoint is enabled.
Example: xConfiguration Conference 1 LyncCompatibility: Off
Set the auto answer mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: An incoming call must be answered manually by pressing the OK key or the green Call key on
the remote control, or by tapping the Accept key on the Touch controller.
On: Enable auto answer to let the system automatically answer all incoming calls.
Example: xConfiguration Conference 1 AutoAnswer Mode: Off
API Reference Guide
xStatus Appendices
Copyright © 2013 Cisco Systems, Inc. All rights reserved.