Cisco TelePresence SX20 Codec Reference Manual page 104

Cisco TelePresence SX20 Codec
Contents Introduction
xCommand Provisioning CUCM CAPF OperationStart
Starts a pending CAPF (Certificate Authority Proxy Function) operation toward the CUCM. When the
CUCM administrator initiates an operation that the endpoint should perform (like installing, updating
or deleting certificates), this command can be used to start the CAPF operation.
AuthString: Set the authentication string required for the CAPF operation.
Requires user role: USER
Parameters:
AuthString(o): <S: 4, 10>
Example:
xCommand Provisioning CUCM CAPF OperationStart AuthString: 123456
*r CAPFStartResult (status=OK):
** end
xCommand Provisioning CUCM CTL Delete
Delete the stored CTL and ITL files (CTL: Certificate Trust List, ITL: Identity Trust List).
Requires user role: USER
Example:
xCommand Provisioning CUCM CTL Delete
*r DeleteResult (status=OK):
** end
SX20 Codec API Reference Guide TC6.2, JULY 2013.
D14949.04
About the API xConfiguration
Security commands
xCommand Security FIPSMode Activate
104
xCommand xCommand
Activate FIPS (140-2) mode. NOTE: Activating FIPS mode implies a reset to factory defaults.
While in FIPS mode, software upgrade is disabled and the following limitations apply: All calls are
encrypted, unencrypted communication protocols like Telnet and HTTP cannot be used. IEEE802.1x
and SNMP are disabled. The SIP Profile Type setting cannot be Microsoft. The root user is not
available (root settings cannot be changed).
To exit FIPS mode, perform a factory reset.
Confirm: <Yes>
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
Example:
xCommand Security FIPSMode Activate Confirm: "Yes"
OK
*r SecurityFIPSModeActivateConfirmResult (status=OK)
** end
API Reference Guide
xStatus Appendices
Copyright © 2013 Cisco Systems, Inc. All rights reserved.