Conference Configuration - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction

Conference configuration

xConfiguration Conference [1..1] CallProtocolIPStack
Select if the system should enable IPv4, IPv6, or dual IP stack on the call protocol (SIP, H323).
Requires user role: ADMIN
Value space: <Dual/IPv4/IPv6>
Dual: Enables both IPv4 and IPv6 for H323 and SIP calls.
IPv4: When set to IPv4, the call protocol (SIP, H323) will use IPv4.
IPv6: When set to IPv6, the call protocol (SIP, H323) will use IPv6.
Example: xConfiguration Conference 1 CallProtocolIPStack: Dual
xConfiguration Conference [1..1] AutoAnswer Mode
Set the auto answer mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: An incoming call must be answered manually by pressing the OK key or the green Call key on
the remote control, or by tapping the Accept key on the Touch screen control panel.
On: Enable auto answer to let the system automatically answer all incoming calls.
Example: xConfiguration Conference 1 AutoAnswer Mode: Off
xConfiguration Conference [1..1] AutoAnswer Mute
Determine if the microphone shall be muted when an incoming call is automatically answered.
Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Value space: <Off/On>
Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.
Example: xConfiguration Conference 1 AutoAnswer Mute: Off
SX20 Codec API Reference Guide TC7.0, JANUARY 2014.
D14949.08
About the API xConfiguration xConfiguration
xConfiguration Conference [1..1] AutoAnswer Delay
xConfiguration Conference [1..1] MicUnmuteOnDisconnect Mode
xConfiguration Conference [1..1] DoNotDisturb Mode
33
xCommand
Define how long (in seconds) an incoming call has to wait before it is answered automatically by the
system. Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Value space: <0..50>
Range: Select a value from 0 to 50 seconds.
Example: xConfiguration Conference 1 AutoAnswer Delay: 0
Determine if the microphones shall be unmuted automatically when all calls are disconnected. In a
meeting room or other shared resources this may be done to prepare the system for the next user.
Requires user role: ADMIN
Value space: <Off/On>
Off: If muted during a call, let the microphones remain muted after the call is disconnected.
On: Unmute the microphones after the call is disconnected.
Example: xConfiguration Conference 1 MicUnmuteOnDisconnect Mode: On
Determine whether to allow incoming calls.
Requires user role: USER
Value space: <Off/On/Timed>
Off: The incoming calls will come through as normal.
On: All incoming calls will be rejected and they will be registered as missed calls. The calling side
will receive a busy signal. A message telling that Do Not Disturb is switched on will display on the
Touch screen control panel or main display. NOTE: This setting is not recommended as all calls will
be rejected until the setting is manually turned off. The recommended option is Timed.
Timed: When set to timed (default), the system will revert back and allow incoming calls after the
specified timeout, defined by the setting: Conference DoNotDisturb DefaultTimeout.
Example: xConfiguration Conference 1 DoNotDisturb Mode: Timed
API Reference Guide
xStatus Appendices
Copyright © 2014 Cisco Systems, Inc. All rights reserved.