Conference Configuration - Cisco TelePresence System Codec C20 Reference Manual

Cisco TelePresence System Codec C20
Contents Introduction
xConfiguration Cameras Camera [1..1] Whitebalance Level
Set the whitebalance level. NOTE: Requires the Camera Whitebalance Mode to be set to manual.
Requires user role: ADMIN
Value space: <1..16>
Range: Select a value from 1 to 16.
Example: xConfiguration Cameras Camera 1 Whitebalance Level: 1
xConfiguration Cameras Camera [1..1] DHCP
Applies to cameras which support DHCP (for example the Cisco TelePresence PrecisionHD 1080p
12X camera). The camera must be connected to a LAN. When set, the command enables support
for SW upgrade of daisy chained cameras. It will enable the camera's DHCP function and force
start of MAC and IP address retrieval. Remember to reset the DHCP when the camera is no longer
connected to a LAN.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable DHCP in the camera. NOTE: This setting should be applied when the camera is not
connected to a LAN.
On: Enable DHCP in the camera. The camera is automatically re-booted. After re-boot the DHCP
is started and the IP address will be retrieved. Run the commnand "xStatus Camera" for result.
Example: xConfiguration Cameras Camera 1 DHCP: Off
Codec C20 API Reference Guide TC7.0, JANUARY 2014.
D14869.11
About the API xConfiguration xConfiguration

Conference configuration

xConfiguration Conference [1..1] CallProtocolIPStack
xConfiguration Conference [1..1] AutoAnswer Mode
xConfiguration Conference [1..1] AutoAnswer Mute
31
xCommand
Select if the system should enable IPv4, IPv6, or dual IP stack on the call protocol (SIP, H323).
Requires user role: ADMIN
Value space: <Dual/IPv4/IPv6>
Dual: Enables both IPv4 and IPv6 for H323 and SIP calls.
IPv4: When set to IPv4, the call protocol (SIP, H323) will use IPv4.
IPv6: When set to IPv6, the call protocol (SIP, H323) will use IPv6.
Example: xConfiguration Conference 1 CallProtocolIPStack: Dual
Set the auto answer mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: An incoming call must be answered manually by pressing the OK key or the green Call key on
the remote control, or by tapping the Accept key on the touch screen control panel.
On: Enable auto answer to let the system automatically answer all incoming calls.
Example: xConfiguration Conference 1 AutoAnswer Mode: Off
Determine if the microphone shall be muted when an incoming call is automatically answered.
NOTE: Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Value space: <Off/On>
Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.
Example: xConfiguration Conference 1 AutoAnswer Mute: Off
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.