Table of Contents
Advertisement
Purging the Module Configuration
---
1
Xbar MAC-Address(es)
---
1
* this terminal session
switch#
Displaying Information for a Specific Supervisor or I/O Module
switch# show module 1
Mod
---
1
Mod
---
1
Mod
---
1
Mod
---
1
Chassis Ejector Support: Enabled
Ejector Status:
Left ejector CLOSE, Right ejector CLOSE, Module HW does support
ejector based shutdown, Ejector policy enabled.
switch#
Displaying Information for a Specific Fabric Module
switch# show module xbar 1
Xbar Ports
---
1
Xbar Sw
---
1
Xbar MAC-Address(es)
---
1
Chassis Ejector Support: Enabled
Ejector Status:
Top ejector OPEN, Bottom ejector OPEN, Module HW does not support ejector
based shutdown, Ejector policy disabled.
switch#
Purging the Module Configuration
You can clear the running configuration for an I/O slot that is not functioning by using the purge module
command in EXEC mode.
Cisco Nexus 7718 Switch Site Preparation and Hardware Installation Guide
80
--------------
------
NA
0.101
--------------------------------------
NA
Ports
Module-Type
-----
--------------------------------- ---------------- ------
48
1/10 Gbps Ethernet Module
Sw
Hw
--------------
------
7.3(0)DX(1)
0.701
MAC-Address(es)
--------------------------------------
50-06-ab-91-05-a0 to 50-06-ab-91-05-d3
Online Diag Status
------------------
Pass
Module-Type
-----
----------------------------------- ------------------ ------
0
Fabric Module 1
Hw
--------------
------
NA
0.101
--------------------------------------
NA
Serial-Num
----------
JAF1225AGHJ
Model
Status
N77-M348XP-23L
ok
Serial-Num
----------
JAE194108S6
Model
Status
N77-C7706-FAB-2
ok
Serial-Num
----------
JAE17260CCT
Managing the Switch
OL-30453-01
Advertisement
Table of Contents
