Cisco Nexus 7718 Hardware Installation Manual page 203

Table of Contents

Advertisement

LEDs
LED
SYSTEM
ACTIVE
PWR MGMT
MGMT ETH
LINK
ACT
LOG FLASH
Slot 0
OL-30453-01
Color
Status
Green
All chassis environmental monitors are reporting okay.
Amber
At least one power supply has failed or the power supply fan has failed.
Red
The temperature of the supervisor engine major threshold has been
exceeded.
Off
The slot has detected a slot ID parity error.
Green
The supervisor module is operational and active.
Amber
The supervisor module is in standby mode.
Green
Sufficient power is available for all of the installed modules.
Amber
Insufficient power is available for all of the installed modules.
Green
The management port is operational.
Amber
The management port link has been disabled through the software.
Flashing
The management port link is bad and has been disabled due to a
amber
hardware failure.
Off
The module has not detected a signal.
Green
The module has detected a link.
Off
The module does not detect a link.
Flashing green
The module is transmitting or receiving.
Off
The module is not transmitting or receiving.
Green
The log flash CompactFlash or USB disk is being accessed. Do not
remove the media until the LED is off.
Off
The expansion flash CompactFlash or USB disk is not being accessed.
You can remove the media while this LED is off.
Green
The expansion flash CompactFlash or USB disk is being accessed. Do
not remove the media until the LED is off.
Off
The log flash CompactFlash or USB disk is not being accessed. You
can remove the media while this LED is off.
Cisco Nexus 7718 Switch Site Preparation and Hardware Installation Guide
Supervisor Module LEDs
193

Advertisement

Table of Contents
loading

Table of Contents