Table of Contents
Advertisement
Replacing a Fan Tray
b) Tilt the top of the fan tray toward the chassis and press it part way into the slot so that the alignment pins
are part way into their holes in the chassis and the spring clip at the top of the module is inside the fan-tray
slot and behind the outer surface of the chassis.
Figure 33: Installing a Fan Tray
1
2
Cisco Nexus 7718 Switch Site Preparation and Hardware Installation Guide
116
Align four pins in the fan tray to four holes in
the chassis.
Position the spring clip behind the edge of the
chassis and then press the whole fan tray into
the chassis slot.
Installing or Replacing Modules, Fan Trays, and Power Supplies
3
Tighten four captive screws to 8 in-lb (0.9
N·m).
OL-30453-01
Advertisement
Table of Contents
