Table of Contents
Advertisement
Installing the Chassis
in the front corner of the top hood, release that spring pin so that it goes into that hole. When both spring
pins are released and the door can swing open and closed, the door is remounted.
e) Repeat Steps 1a through 1d once for the other side door.
Step 2
Install the two cable-management filters on the left and right cable management frames as follows:
a) Align the five screw holes in one of the two cable management air filters to five screw holes in one of the
upper cable management frames as shown in the following figure.
Figure 25: Attaching a Cable-Management Frame Air Filter
1
OL-30453-01
Air filter for cable management frame
Cisco Nexus 7718 Switch Site Preparation and Hardware Installation Guide
Installing the Air Filters
2
Five M3 x 13 mm screws for each air filter
51
Advertisement
Table of Contents
