Purging A Nonfunctioning Module From The Running Configuration; Displaying Power Usage Information - Cisco Nexus 9508 Hardware Installation Manual

Purging a Nonfunctioning Module from the Running Configuration

Example:
switch# configure terminal
switch(config)#
Step 2 Shut down (or alternatively power up) a specific module by entering the [no] poweroff module slot_number command.
Example:
switch(config)# poweroff module 3
switch(config)#
Example:
switch(config)# no poweroff module 3
switch(config)#
Purging a Nonfunctioning Module from the Running
Configuration
Verify that either the system controller, line card, or fabric slot is empty or that the module installed in the
slot is powered down.
You can clear the running configuration for a system controller, line card, or fabric slot (slots 1 to 30) that is
not functioning by using the purge module command in EXEC mode.
This command does not work on supervisor slots or on any line card slot that currently has a powered-up
Note
module or on blank modules. Use the purge module slot_number runnning-config command to clear the
running configuration for the specified line card slot.
switch# purge module 4 running-config
For example, suppose that you create an IP storage configuration with a line card in slot 3 of Switch A. This
module uses an IP address. You decide to remove this line card module and move it to Switch B, and you no
longer need the IP address. If you try to configure this unused IP address, you receive an error message that
prevents you from proceeding with the configuration. In this case, you need to enter the purge module 3
running-config command to clear the old configuration in Switch A before using the IP address.

Displaying Power Usage Information

To display the power usage information for the entire switch, use the show environment power command.
This command shows the power usage for the power consuming modules installed in the switch.
Note Power usage is reserved for both supervisor modules regardless of whether one or both supervisor modules
are present.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
60
Managing the Switch