Cisco Nexus 7718 Hardware Installation Manual page 60

Installing the Air Filters
b) Align the six alignment holes on the largest filter to six alignment studs on the open side of the door as
shown in the following figure.
Figure 24: Aligning a Door Filter to a Door
1
2
3
4
c) Press the filter onto the alignment studs and use two __ x __ mm screws to secure the filter to the door.
d) Reattach the door to the chassis by pulling in its two spring pins, inserting the door edge between the top
hood and the divider bracket on the cable management frames. When each spring pin is aligned to a hole
Cisco Nexus 7718 Switch Site Preparation and Hardware Installation Guide
50
Front door, back side facing up
Air filter for inside of door
Alignment pins (two on the top, side, and
bottom of the door
Screws (3) used to secure filter to the door
5 Air filter for the side of the door
6 Captive screws (one on each end)
7 Screw hole for captive screw on filter
Installing the Chassis
OL-30453-01