Configuring Soft Reload
Configuring Soft Reload
Enabling the Switch to Perform a Soft Reload After a Process Crash
Procedure
Step 1
Enter global configuration mode:
switch# configure terminal
Step 2
Enable the switch to perform a soft reload after a process crash:
switch(config)# system soft-reload enable
Step 3
(Optional) Display the status of the soft reload:
switch# show system soft-reload status
Running Configuration
This example shows a running configuration, followed by a verification command that displays the status of
the soft reload.
configure terminal
system soft-reload enable
.
.
.
switch# show system soft-reload status
Soft-reload is enabled
Performing a Manual Soft Reload
Procedure
Step 1
(Optional) Display the status of the soft reload:
switch# show system soft-reload status
Step 2
Perform a manual soft reload of the switch:
switch(config)# soft-reload
Running Configuration
This example shows a verification command that displays the status of the soft reload, followed by the
command to initiate a manual soft reload.
show system soft-reload status
Soft-reload is disabled
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
280
Soft Reload
OL-31641-01