Enabling Cfs Distribution For Ntp - Cisco Nexus 3548 series Configuration Manual

Enabling CFS Distribution for NTP

Step 3
Step 4
Example
This example shows how to enable NTP logging in order to generate system logs with significant
NTP events:
switch# config t
switch(config)# ntp logging
switch(config)# copy running-config startup-config
[########################################] 100%
switch(config)#
Enabling CFS Distribution for NTP
You can enable CFS distribution for NTP in order to distribute the NTP configuration to other CFS-enabled
devices.
Before you begin
Make sure that you have enabled CFS distribution for the device.
Procedure
Step 1
Step 2
Step 3
Step 4
Example
This example shows how to enable CFS distribution for NTP:
switch# config t
Enter configuration commands, one per
line. End with CNTL/Z.
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
30
Command or Action
(Optional) switch(config)# show ntp
logging-status
(Optional) switch(config)# copy
running-config startup-config
Command or Action
switch# configure terminal
switch(config)# [no] ntp distribute
(Optional) switch(config)# show ntp status
(Optional) switch(config)# copy
running-config startup-config
Purpose
Displays the NTP logging configuration status.
Saves the change persistently through reboots
and restarts by copying the running
configuration to the startup configuration.
Purpose
Enters global configuration mode.
Enables or disables the device to receive NTP
configuration updates that are distributed
through CFS.
Displays the NTP CFS distribution status.
Saves the change persistently through reboots
and restarts by copying the running
configuration to the startup configuration.
Configuring NTP