Default Settings For Ptp; Configuring Ptp; Configuring Ptp Globally - Cisco Nexus 5600 Series Configuration Manual

Configuring PTP

Default Settings for PTP

The following table lists the default settings for PTP parameters.
Table 2: Default PTP Parameters
Parameters
PTP
PTP version
PTP domain
PTP priority 1 value when advertising the clock
PTP priority 2 value when advertising the clock
PTP announce interval
PTP announce timeout
PTP minimum delay request interval
PTP VLAN
Configuring PTP

Configuring PTP Globally

You can enable or disable PTP globally on a device. You can also configure various PTP clock parameters
to help determine which clock in the network has the highest priority to be selected as the grandmaster.
Procedure
Step 1
Step 2
Step 3
OL-31641-01
Command or Action
switch# configure terminal
switch(config) # [no] feature
ptp
switch(config) # [no] ptp source
ip-address [vrf vrf]
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
Default
Disabled
2
0. PTP multi domain is disabled by default.
255
255
1 log second
3 announce intervals
0 log seconds
1
Purpose
Enters global configuration mode.
Enables or disables PTP on the device.
Enabling PTP on the switch does not enable PTP on
Note
each interface.
Configures the source IP address for all PTP packets.
The ip-address can be in IPv4 or IPv6 format.
Default Settings for PTP
63