Cisco Nexus 5600 Series Configuration Manual page 233

Configuring ERSPAN
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
OL-31641-01
Command or Action
enable
Example:
switch> enable
configure terminal
Example:
switch# configure terminal
switch(config)#
interface ethernet slot/port
Example:
switch(config)# interface ethernet 1/1
packet latency threshold threshold
Example:
switch(config-if)# packet latency
threshold 53000000
monitor session session_number type
span-on-latency-erspan
Example:
switch(config)# monitor session 1 type
span-on-latency-erspan
switch(config-span-on-latency-erspan)#
description description
Example:
switch(config-span-on-latency-erspan)#
description
SPAN-on-Latency-ERSPAN-session
source interface ethernet slot/port
Example:
switch(config-span-on-latency-erspan)#
source interface ethernet 1/3
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
Configuring an ERSPAN SPAN-on-Latency Session
Purpose
Enables privileged EXEC mode. Enter your
password if prompted.
Enters global configuration mode.
Enters interface configuration mode.
Configures the latency threshold value on an
interface. Valid values are from 8 to 536870904
nano seconds.
Defines an ERSPAN source session using the
session ID and the session type, and places the
command in ERSPAN monitor source session
configuration mode.
The session_number argument range is from 1 to
1024. The same session number cannot be used
more than once.
The session ID (configured by the span_session
number argument) and the session type (configured
by the span-on-latency-erspan keyword) cannot be
changed once entered. To change session ID or
session type, use the no version of the command
to remove the session and then re-create the session
through the command with a new session ID or a
new session type.
Adds a description to the session configuration.
Specifies the Ethernet interface to use as the source
SPAN port.
You can configure multiple SPAN source
Note
ports.
211