Dumping Snapshot Sections; Entering Maintenance Mode - Cisco Nexus 5600 Series Configuration Manual

Configuring GIR (Cisco NX-OS Release 7.3(0)N1(1))

Dumping Snapshot Sections

Procedure
Step 1
The following example shows how to dump content of the various sections in a generated snapshot:
switch#
File:
===========================================================================
<?xml version="1.0" encoding="ISO-8859-1"?>
<nf:rpc-reply xmlns:nf="urn:ietf:params:xml:ns:netconf:base:1.0" xmlns="http://w
ww.cisco.com/nxos:7.3.0.N1.1.:if_manager">
<nf:data>
<show>
<interface>

Entering Maintenance Mode

If you are going to create your own profile rather than using the system mode maintenance command to do
it for you, see the
Procedure
Step 1
Step 2
OL-31641-01
<attached>false</attached>
... <snip>
</ROW_prefix>
Command or Action
switch# show snapshots dump
snapshot-name
show snapshots dump new
interface.xml
<__readonly__>
<TABLE_interface>
<ROW_interface>
<interface>mgmt0</interface>
<state>up</state>
<admin_state>up</admin_state>
<eth_hw_desc>GigabitEthernet</eth_hw_desc>
<eth_hw_addr>5cfc.666d.3b34</eth_hw_addr>
<eth_bia_addr>5cfc.666d.3b34</eth_bia_addr>
<eth_ip_addr>5.24.100.101</eth_ip_addr>
<eth_ip_mask>16</eth_ip_mask>
<eth_ip_prefix>5.24.0.0</eth_ip_prefix>
<eth_mtu>1500</eth_mtu>
... <snip> ...
Configuring Custom Maintenance Mode and Custom Normal Mode Profile
Command or Action
switch# configure terminal
switch(config)# system
mode maintenance
[always-use-custom-profile Use the dont-generate-profile and shutdown options to put the switch
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
Purpose
Displays the content of the various sections in a
generated snapshot.
Snapshot: new
Purpose
Enters global configuration mode.
Puts all enabled protocols in maintenance mode (using the isolate
command).
in maintenance mode.
Dumping Snapshot Sections
section.
295