Configuring Logging Timestamps - Cisco Nexus 5600 Series Configuration Manual

Configuring Logging Timestamps

Step 4
Step 5
Step 6
Step 7
Step 8
The following example shows how to configure the severity level of module and specific facility messages:
switch# configure terminal
switch(config)# logging module 3
switch(config)# logging level aaa 2
Configuring Logging Timestamps
You can configure the time-stamp units of messages logged by the Cisco Nexus Series switch.
Procedure
Step 1
Step 2
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
102
Command or Action
switch(config)# no logging
module [severity-level]
switch(config)# no logging
level [facility severity-level]
switch# show logging module
switch# show logging level
[facility]
switch# copy running-config
startup-config
Command or Action
switch# configure terminal
switch(config)# logging timestamp
{microseconds | milliseconds | seconds}
Purpose
To apply the same severity level to all facilities, use the all
facility. For defaults, see the show logging level command.
If the default severity and current session severity of a
Note
component is the same, then the logging level for the
component will not be displayed in the running
configuration.
(Optional)
Disables module log messages.
(Optional)
Resets the logging severity level for the specified facility to its
default level. If you do not specify a facility and severity level,
the switch resets all facilities to their default levels.
(Optional)
Displays the module logging configuration.
(Optional)
Displays the logging level configuration and the system default
level by facility. If you do not specify a facility, the switch
displays levels for all facilities.
(Optional)
Copies the running configuration to the startup configuration.
Purpose
Enters global configuration mode.
Sets the logging time-stamp units. By default,
the units are seconds.
Configuring System Message Logging
OL-31641-01