Installation Safety - Redline RDL-3000 Installation Manuallines

RDL-3000 INSTALLATION GUIDELINES
Warning Symbols
These symbols may be encountered during installation or troubleshooting. These
warning symbols mean danger. Bodily injury may result if you are not aware of the safety
hazards involved in working with electrical equipment and radio transmitters. Familiarize
yourself with standard safety practices before continuing.
WARNING
WARNING
WARNING
HOT SURFACE
ELECTRO-MAGNETIC
HIGH VOLTAGE
RADIATION
DO NOT TOUCH
1.2

Installation Safety

Professional Installation / Installations Professionnel
Redline RDL-3000 devices require professional installation. It is the responsibility of the
installer to be sure that all building and safety codes are met and that the installation is
complete and secure.
The RDL-3000 shall be installed according to local Electrical Safety Codes.
For Canadian installations, the entire equipment installation must comply with
Canadian Standard CSA 22.2, No. 60950, Safety of Information Technology
Equipment. For installations in the United States, the entire equipment installation
must be in accordance with Article 810 of the United States National Electrical
Code.
Les appareils RDL-3000 de Redline doivent être installés par un personnel
professionnel. Le personnel responsable doit s'assurer que l'installation est bien
achevée, et qu'elle répond aux exigences de tous les codes de sécurité.
Une installation faite au Canada doit observer les normes 22.2, numéro 60950 du CSA,
Sécurité des matériels de traitement de l'information. Une installation faite aux États-
Unis doit être faite selon les stipulations de l'Article 810 du United States National
Electrical Code.
Safety Precautions
Installation and service must be done by personnel having technical training and
experience necessary to be aware of hazards during installation and/or service of
outdoors RF equipment. The installation and/or service must be done using procedures
designed to minimize any danger to technical personnel or any other person.
Use safety devices when working on or around the mast. Be aware of the risk of falling
objects. Use provided safety catches when hoisting antennas and radios.
Do not use any components (screws, nuts, etc.) other than those delivered together with
the Redline microwave radio equipment or those recommended by Redline.
Electrocution Hazard / Risque D'électrocution
Warning to Service Personnel: 48 VDC
This product is intended to be connected to a –36 to -57 VDC power source, which
must be electrically isolated from any ac sources and reliably connected to Earth
ground. Do not install Redline products near any type of power line. Should your
antenna or related hardware come in contact with power lines, severe bodily harm or
death could result!
70-00159-01-06 Proprietary Redline Communications © 2012 Page 9 of 65 kune 12, 2012