Web Browser (Http); Audible Alignment Tool; Mounting Kits; Grounding - Redline RDL-3000 Installation Manuallines

RDL-3000

Web Browser (HTTP)

To monitor and configure the RDL-3000 using HTTP, open a Web browser (Internet
Explorer 6 or higher recommended) and enter the unit IP address. For new systems, the
default IP address is 192.168.25.2. The following login dialog should be displayed:
The default username is 'admin' and the default password is 'admin'.
Note: There is no logout command on the Web interface.

Audible Alignment Tool

The audible alignment tool is provided to assist the installer to perform basic antenna
alignment. When enabled, the audible alignment signal 'chirps' slowly when a low signal
level is detected, and faster when stronger signals are detected. Use the Web or CLI
interface to enable and disable the tool.
3.5

Mounting Kits

Lightweight Mounting Kit
Lightweight mounting kit includes mounting bracket with assembly hardware. Fits 25-105
mm (1.0-4.25 in) mast pipe or mounts on a flat surface. Two 230 mm (9 in) RF jumper
cables (N-type connectors, 50 Ohm)
Heavy-Duty Mounting Kit
Heavy-duty mounting kit includes mounting bracket with assembly hardware. Fits 45-110
mm (1.75-4.5 in) mast. Two 400 mm (16 in) RF jumper cables (N-type connectors, 50
Ohm) are included with each mounting kit.
3.6

Grounding

Ground Lug

A ground-lug
a grounding wire. All RDL-3000 systems must be properly grounded to protect against
power surges and accumulated static electricity.
70-00159-01-06
INSTALLATION GUIDELINES

Figure 7: Features - Web Login to the RDL-3000

is provided on the RDL-3000 chassis. Use this connection to terminate
Proprietary Redline Communications © 2012
are included with each mounting kit.
Page 20 of 65 kune 12, 2012