Configuration; Step 1: Login To Rdl-3000; Figure 40: Procedures - Basic Wiring Configuration For Web/Telnet Access - Redline RDL-3000 Installation Manuallines

RDL-3000
5.5

Configuration

Use the following steps to setup a basic link between the PMP sector controller and a
single subscriber:
Setup the test PC and login to the Web or CLI management interface.
1.
Factory reset the RDL-3000
2.
Enter the options keys
3.
Configure the basic wireless parameters
4.
Provision a Link, Service, and Service Group
5.
5.5.1

Step 1: Login to RDL-3000

The RDL-3000 can be configured and monitored using Telnet or a standard Web
browser (e.g., Internet Explorer 6.0 or higher). The following procedures require a PC
equipped with a Web browser, Ethernet port, and an Ethernet Cat-5e crossover cable for
connecting the PC to the PoE power adapter.

Figure 40: Procedures - Basic Wiring Configuration for Web/Telnet Access

The IP address of the test PC must be on the same subnet as the RDL-3000. For
example:
IP address = 192.168.25.11
Net Mask =
70-00159-01-06
INSTALLATION GUIDELINES
255.255.255.0
Proprietary Redline Communications © 2012 Page 47 of 65 kune 12, 2012