Rf And Network Information; Table 7: Site Survey - Rf And Network Information; Figure 10: Site Survey - Non-Line Of Sight Deployment - Redline RDL-3000 Installation Manuallines

RDL-3000
A clear line-of-sight (LOS) path requires clearance above natural and man-made objects
by at least 60% of the First Fresnel zone. Each antenna should be positioned to provide
maximum clearance in the first Fresnel zone of the direct signal path.
The RDL-3000 also functions under optical line-of-sight (OLOS) conditions; where a
clear straight line path exists between the two end points, but the first Fresnel zone is
not clear of obstacles. If the optical path is completely blocked, it may be possible to
establish a non line-of-sight (NLOS) path using RF signal reflections, such as a common
reflective structure (e.g., office building) that is LOS for the antennas of communicating
units.
4.1.3

RF and Network Information

The following table contains the minimum set of parameters required to configure an
RDL-3000 sector controller and subscriber. Parameters should be configured in the
order listed. Enter values for all required settings on each screen and then click Apply &
Save to activate and save these changes.
Step Screen
1 Utilities
->Product
Options
2 Configuration
->System
3 Configuration
->Wireless
Provisioning
4
->Subscriber
Links
Notes: 1. DHCP is available for the SC and SS. 2. DFS enabled systems only.
70-00159-01-06
INSTALLATION GUIDELINES

Figure 10: Site Survey - Non-Line of Sight Deployment

Table 7: Site Survey - RF and Network Information

Parameter
Options Key
System Name
1
IP Address
System Mode
Channel Width
RF Freq.
Tx Power
Max. Distance
2
Antenna Gain
Subscriber
MAC
Proprietary Redline Communications © 2012
Ref. Sector Controller
RF Plan Enable PMP SC
mode, RF freq.,
etc.
Net. Plan Name for SC
Net. Plan IP address for SC
RF Plan PMP SC
RF Plan Use the same setting for SC and SS.
RF Plan Use the same setting for SC and SS.
RF Plan Refer to RF Plan
RF Plan Refer to RF Plan
RF Plan See Mfg. Spec.
MAC address of
RF Plan
each subscriber in
the sector.
Page
Subscriber
Enable PMP SS
mode, RF freq.,
etc.
Name for SS
IP address for SS
PMP SS
Refer to RF Plan
N/A
See Mfg. Spec.
N/A
23 of 65 kune 12, 2012