Step 5: Create And Enable A Wireless Link; Add A Subscriber Link; Add A Service Group; Figure 43: Procedures - Rdl-3000 Basic Pass-Through Configuration - Redline RDL-3000 Installation Manuallines

RDL-3000
5.5.5

Step 5: Create and Enable a Wireless Link

Using the Provisioning menu, the operator must configure at least one Link, Service, and
Service Group before the sector controller can establish a wireless link, measure signal
strength (e.g., RSSI and SINADR), and pass Ethernet traffic. All provisioning settings are
made on the sector controller (PMP SC).

Figure 43: Procedures - RDL-3000 Basic Pass-Through Configuration

Use the following steps to set up a 'Pass through' configuration (no VLAN support) and
have the RDL-3000 system transparently pass all Ethernet traffic. The steps must be
performed in the order they are listed.

Add a Subscriber Link

Create a Subscriber Link named 'Link-1' and configure the wireless link.
Click Provisioning->New Subscriber Link in the main menu.
1.
Enter data for the following fields:
2.
Link Name: Link-1
3.
Peer MAC: [Subscriber MAC address]
4.
Use defaults for all other fields.
5.
Click Apply to activate these settings.
6.
Click Save All in the main menu to save changes to the provisioning configuration.
7.
Repeat these steps to add additional links if required.

Add a Service Group

Create a Service Group named 'Group-1' to forward all Ethernet traffic received on the
sector controller Ethernet port.
Click Configuration->Service Group in the web page main menu.
1.
Click the Add New button and enter data for the following fields:
2.
Name: Group-1
3.
Tagging mode: Pass-through
4.
SC Ethernet Enable: Click to check the box
5.
Use defaults for all other fields.
6.
Click Apply to activate this Service Group.
7.
Click Save All in the main menu to save changes to the provisioning configuration.
8.
70-00159-01-06
INSTALLATION GUIDELINES
Proprietary Redline Communications © 2012
.
Page 53 of 65 kune 12, 2012