Weatherproofing The Lp Ports; Figure 36: Procedures - Ethernet Surge Protector - Weatherproofing Pt-1; Figure 37: Procedures - Ethernet Surge Protector - Weatherproofing Pt-2; Figure 38: Procedures - Ethernet Surge Protector - Weatherproofing Pt-3 - Redline RDL-3000 Installation Manuallines
Radio platform
Hide thumbs
Also See for RDL-3000:
- User manual (150 pages) ,
- Installation manuallines (59 pages) ,
- Configuration instructions (9 pages)
Table of Contents
Advertisement
RDL-3000
Weatherproofing the LP Ports
It is important to weatherproof both ends of the line protection unit.
Begin to wrap the splicing tape. Start as close to the LP housing as possible. Stretch
1.
and wind the tape back along the connector housing making very sure there are no
gaps in the tape.
Figure 36: Procedures - Ethernet Surge Protector - Weatherproofing Pt-1
Continue to wrap the tape tightly along the cable.
2.
Figure 37: Procedures - Ethernet Surge Protector - Weatherproofing Pt-2
Work the mastic putty into the area between the connector and the body of the LP.
3.
Continue to work the putty to ensure a watertight seal.
Figure 38: Procedures - Ethernet Surge Protector - Weatherproofing Pt-3
4. Repeat this procedure for both cable connections to the LP.
70-00159-01-06
INSTALLATION GUIDELINES
Proprietary Redline Communications © 2012
Page
45
of 65
kune 12, 2012
- Quick Links:
- Installation Procedures
Hide quick links:
Advertisement
Table of Contents
