2 Panel Operator
2.1.1 Names and Functions
2.1
Overview
2.1.1
Names and Functions
Panel operator consists of display part and keys.
Parameter setting, status display, execution of utility function, and monitoring of the SERVOPACK operation
are enabled using the panel operator.
The names and functions of the keys on the panel operator are as follows.
Note: To reset the servo alarm, press the UP Key and the
2.1.2
Display Selection
Press the MODE/SET Key to make a selection in the following order.
Return to
2-2
Display part
DOWN Key simultaneously. Be sure to remove the
cause and then reset the alarm.
Power ON
Press
MODE/SET
Press
MODE/SET
Press
MODE/SET
Press
MODE/SET
www.dadehpardazan.ir 88594014-15
Key
No.
Keys
for one second.
Press
DATA/
DATA/SHIFT
Press
for one second.
DATA/
DATA/SHIFT
Press
for one second.
DATA/
DATA/SHIFT
Key Name
Function
• To select a display.
MODE/SET
Key
• To set the set value.
UP Key
To increase the set value.
DOWN Key
To decrease the set value.
• To display the set value by
pressing this key for one
DATA/SHIFT
second.
Key
• To move to the next digit
on the left when flashing.
Status Display (Refer to 2.3)
(Refer to 2.1.3.)
Fn
: Utility Function
(Refer to 2.4)
(Refer to 2.2.)
Pn
: Parameter Setting
(Refer to 2.3.)
(Refer to 2.6)
Un
: Monitor Display
(Refer to 2.4.)
(Refer to 2.7)
Analog