Advanced Autotuning By Reference Procedure - YASKAWA SGDV SERVOPACK User Manual

6 Adjustments

6.4.2 Advanced Autotuning by Reference Procedure

6.4.2 Advanced Autotuning by Reference Procedure

The following procedure is used for advanced autotuning by reference.
Advanced autotuning by reference is performed from the digital operator (option) or SigmaWin+. The func-
tion cannot be performed from the panel operator.
Here, the operating procedure from the digital operator is described.
Refer to the
operations of the digital operator.
(1) Operating Procedure
Set the correct mass ratio in Pn103 by using the advanced autotuning before performing this procedure.
Step
1
2
3
3-1
3-2
4
5
6
6-30

-V Series User's Manual, Operation of Digital Operator (No.: SIEP S800000 55) for basic key
Display after Operation
Status Display
Mode Selection
Select the mode.
Mode = 1: Makes adjustments considering response characteristics and stability (Standard level).
Mode = 2: Makes adjustments for positioning [Factory setting].
Mode = 3: Makes adjustments for positioning, giving priority to overshooting suppression.
Type Selection
Select the type according to the machine element to be driven.
If there is noise or the gain does not increase, better results may be obtained by changing the rigidity type.
Type = 1: Low rigidity
Type = 2: Medium rigidity [Factory setting]
Type = 3: High rigidity
www.dadehpardazan.ir 88594014-15
Keys
Press the
utility function.
Use the or
select Fn202.
Press the Key to display the initial setting screen
for advanced autotuning by reference.
Press the ,
steps 3-1 and 3-2.
Press the
erence execution screen will be displayed.
Note: If the mode is set to 1, Pn102 is displayed. If
the mode is set to 2 or 3, the Pn102 display will
change to the Pn141.
Input servo ON signal (/S-ON) from an external
device.
Input a reference from the host controller and then
press the or
"ADJ" will flash during adjustment on the status dis-
play.
Note: Adjustment cannot be performed during "BB"
is shown on the status display.
Operation
Key to view the main menu for the
Key to move through the list and
, or Key and set the items in
Key. The advanced autotuning by ref-
Key to start the adjustment.