Enabling The Snmp Interface; How To Enable The Snmp Interface; How To Disable The Snmp Interface; Configuring And Managing The Snmp Interface - Cisco SCE8000 Configuration Manual
Service control engine
Hide thumbs
Also See for SCE8000:
- Installation and configuration manual (248 pages) ,
- Installation manual (51 pages) ,
- Removal and replacement procedures (36 pages)
Table of Contents
Advertisement
Chapter 5
Configuring the Management Interface and Security
Enabling the SNMP Interface
Use this command to explicitly enable the SNMP interface.
The SNMP interface is implicitly enabled when any snmp-server command is executed to configure any
SNMP parameter. For more information on configuring and managing the SNMP parameters, including
hosts, communities, contact, location, and trap destination hosts (See
SNMP Interface, page
•
•
How to Enable the SNMP Interface
You must define at least one community string to allow SNMP access. For complete information on
community strings (See
Step 1
From the SCE(config)# prompt, type snmp-server enable and press Enter.
How to Disable the SNMP Interface
Step 1
From the SCE(config)# prompt, type no snmp-server and press Enter.
Configuring and Managing the SNMP Interface
•
•
•
About the SNMP Interface
This section explains how to configure the SNMP agent parameters. It also provides a brief overview of
SNMP notifications and the supported MIBs.
•
•
•
•
•
OL-16479-01
5-25).
How to Enable the SNMP Interface, page 5-25
How to Disable the SNMP Interface, page 5-25
Configuring SNMP Community Strings, page
About the SNMP Interface, page 5-25
Configuring SNMP Community Strings, page 5-28
How to Configure SNMP Notifications, page 5-29
SNMP Protocol, page 5-26
Security Considerations, page 5-26
About CLI, page 5-27
About MIBs, page 5-27
Configuration via SNMP, page 5-28
Configuring and Managing the SNMP Interface
Configuring and Managing the
5-28).
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
5-25
Advertisement
Table of Contents
