Viewing Configurations - Cisco SCE8000 Configuration Manual

Managing Configurations

Viewing Configurations

When you enter configuration commands, it immediately affects the SCE platform operation and
configuration. This configuration, referred to as the running-config, is saved in the SCE platform volatile
memory and is effective while the SCE platform is up. After reboot, the SCE platform loads the
startup-config, which includes the non-default configuration that was saved by the user, into the
running-config.
The SCE platform provides commands for:
•
•
•
After configuring the SCE platform, you may query for the running configuration using the command
show running-config.
At the Cisco SCE8000# prompt, type show running-config.
Step 1
The system shows the running configuration.
SCE8000#>show running-config
#This is a general configuration file (running-config).
#Created on 12:06:13
#cli-type 1
#version 1
no management-agent notifications notification-list
1417,1418,804,815,1404,1405,1406,1407,1408,400
no management-agent notifications notification-list
402,421,440,441,444,445,446,450,437,457
no management-agent notifications notification-list 3593,3594,3595,10040
snmp-server community "public" ro
RDR-formatter forwarding-mode multicast
RDR-formatter destination 10.56.96.26 port 33000 category number 1 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 2 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 3 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 4 priority 100
interface LineCard 0
connection-mode inline on-failure external-bypass
no silent
no shutdown
attack-filter subscriber-notification ports 80
replace spare-memory code bytes 3145728
interface GigabitEthernet 1/1
ip address 10.56.96.46 255.255.252.0
interface TenGigabitEthernet 3/0/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
interface TenGigabitEthernet 3/1/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
interface TenGigabitEthernet 3/2/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
interface TenGigabitEthernet 3/3/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
Cisco SCE8000 Software Configuration Guide
3-4
Viewing the running configuration with only user-configured (non-default) values: show
running-config
Viewing the running configuration with all the SCE platform running configuration values, whether
default or not: show running-config all-data
Viewing the startup configuration: show startup-config
UTC SUN May 11 2008
Chapter 3 Basic Cisco SCE8000 Platform Operations
OL-16479-01