Interface State Relationship To Speed And Duplex; How To Configure The Speed Of The Management Interface - Cisco SCE8000 Configuration Manual

Configuring the Management Port Physical Parameters

Interface State Relationship to Speed and Duplex

The following table summarizes the relationship between the interface state and speed and duplex.
Note •
•
Table 5-1
Speed
Auto
Auto
10/100
10
10
100
100

How to Configure the Speed of the Management Interface

Options
The following options are available:
•
If the duplex parameter is configured to auto, changing the speed parameter has no effect.
From the SCE(config if)# prompt, type speed 10|100|auto and press Enter.
Step 1
Specify the desired speed option.
Configuring the Speed of the Management Interface: Example
The following example shows how to use this command to configure the Management port to 100 Mbps
speed.
SCE(config-if)#speed 100
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
5-4
It is not possible to set one parameter to "Auto" and to specify the other parameter. If either speed
or duplex is set to "Auto", then both parameters will behave as if set to "Auto".
Due to the nature of the interface, 1000Mbps operation is only available when auto-negotiation is
enabled.
Interface State Relationship to Speed and Duplex
speed — speed in Mbps of the currently selected management port (0/1 or 0/2):
– 10
– 100
auto (default) — auto-negotiation (do not force speed on the link)
–
Chapter 5 Configuring the Management Interface and Security
Duplex
Auto
Full/Half
Auto
Full
Half
Full
Half
Actual FE Interface State
Auto negotiation
Auto negotiation
Auto negotiation
10 Mbps and full duplex
10 Mbps and half duplex
100 Mbps and full duplex
100 Mbps and half duplex
OL-16479-01