Configuring The Scmp Peer Device To Force Each Subscriber To Single Sce Platform; Defining The Keep-Alive Interval Parameter - Cisco SCE8000 Configuration Manual

Configuring the SCMP

Configuring the SCMP Peer Device to Force Each Subscriber to Single SCE Platform

When SCMP establishes a connection with an SCMP peer device, it informs the device whether the
SCMP is configured to allow each subscriber to be provisioned to only one SCE platform.
Use this command to configure the SCMP peer device to verify that each subscriber is provisioned to
only one SCE platform. If a subscriber was provisioned to a different SCE platform, the SCMP removes
it from the previous SCE platform and provisions it to the new SCE platform. This configuration is
required in MGSCP topology where, if a fail-over between SCE platforms, subscribers might move from
one SCE platform to another. If transferred subscribers are not cleared from the previous SCE platform,
it can cause capacity issues.
Use the no form of the command to allow SCMP to provision subscribers to more than one SCE
platform.
This configuration takes effect only after the connection is re-established.
Default is disabled (subscribers can be provisioned to more than one SCE platform).
From the SCE(config)# prompt, type scmp subscriber force-single-sce and press Enter.
Step 1
How to Disable Forcing Each Subscriber to Single SCE Platform
Use this command to disable forcing each subscriber to only one SCE platform. This allow subscribers
to be provisioned to more than one SCE platform.
From the SCE(config)# prompt, type no scmp subscriber force-single-sce and press Enter.
Step 1

Defining the Keep-alive Interval Parameter

The keep-alive interval is the amount of time between keep-alive messages to the SCMP peer device. If
the SCMP does not receive a response from the SCMP peer device within the defined interval, the
connection is assumed to be down; and the SCMP changes the connection state to false and begins
attempts to reconnect.
Options
The following options are available:
•
Step 1 From the SCE(config)# prompt, type scmp keepalive-interval interval and press Enter.
Cisco SCE8000 Software Configuration Guide, Rel 3.1.6S
11-8
interval — Interval between keep-alive messages from the SCE platform to the SCMP peer device
in seconds
Default = 5 seconds
–
Chapter 11 Managing the SCMP
OL-16479-01